Connect a 12VDC Device Directly to the FrightProps Beam Sensor

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Home
Support
Controllers & Electronics
Connect a 12VDC Device Directly to the FrightProps Beam Sensor

Connect a 12VDC Device Directly to the FrightProps Beam Sensor

Categories: Controllers & Electronics

A 12VDC strobe alarm is shown in the diagram. This information also applies to other 12VDC devices.

COPYRIGHT © FRIGHTPROPS, LLC. PLEASE CONTACT US IF YOU WOULD LIKE TO REPRODUCE OR REPUBLISH PORTIONS OF THIS DOCUMENT. THE USER ACKNOWLEDGES AND WARRANTS THAT IT BEARS FULL AND COMPLETE RESPONSIBILITY AND LIABILITY FOR THE FINAL DESIGN OF ANYTHING THAT INCORPORATES THE PURCHASED PRODUCTS, INCLUDING FULL AND COMPLETE RESPONSIBILITY AND LIABILITY FOR THE PROPER AND SAFE INSTALLATION, OPERATION, AND MAINTENANCE OF THESE PURCHASED PRODUCT(S).

WARNING: HYDRAULIC AND PNEUMATIC POWER SYSTEMS CAN FAIL THROUGH MISUSE, AGE OR MALFUNCTION. THE SYSTEM DESIGNER IS WARNED TO CONSIDER THE FAILURE MODES OF ALL COMPONENTS USED IN THE DESIGN AND ENGINEERING OF ALL SYSTEMS AND TO PROVIDE ADEQUATE SAFEGUARDS TO PREVENT PERSONAL INJURY OR DAMAGE TO EQUIPMENT IN THE EVENT OF SUCH FAILURES

Halloween Decorations

Animated Props

Prop Making Supplies

Prop Controllers

Escape Room Controllers

Triggers for Controllers

Prop Motors

Servo Products

Linear Actuators

Motor Controllers

Motor Power

Motorized Mechs

Motor Linkage, Arms, Shaft

Motor Mounting

Scents & Smells

Connect a 12VDC Device Directly to the FrightProps Beam Sensor