Wireless Trigger (1-Relay)
As low as $19.99
Programming:
The remote must be trained to the base unit for these to function. Several modes of operation are available. To train the remote, first make sure the remote has a battery in it (remotes are sometimes shipped without batteries). With power to the unit follow these steps to train the base station to the remote:
5. Pressing the remote button should now turn the relay on for as long as you hold the button down.
The module has one relay (10 amps max) on screw down terminal blocks. PicoBoos, BooBoxs, lights, or any other device that can be triggered from a relay can now be activated wirelessly. Use with all FrightProps controllers and audio players or your own devices with trigger input.
Package Includes:
- 1 x Control Switch Board with one 10-amp relay on it
- 1 x Remote Control with one button
Requires a 12VDC Power Supply. If you are powering from another device (such as a PicoBoo) then you will not require one.
Specifications:
- Operating frequency: 315MHz
- Working voltage: DC12V
- Operating current: 8.9Ma
- Receiver sensitivity:-95dB
- Encoding type: pad
- Maximum Load: 10A
- Size: 40mm X 37mm X 25mm(approx)
- Control size: 60x38x18mm(approx)
Please Note:
- Actual antenna range will vary greatly depending on the installation and operating environment
- All units use the same frequency and there is not a way to change that. What this means is that two units cannot be used in the same location and be triggered separately
